Home > Archive > Ethernet > November 2004 > Question about link-flap errors
You are viewing an archived Text-only version of the thread.
To view this thread in it's original format and/or if you want to reply to
this thread please [click here]
| Author |
Question about link-flap errors
|
|
| jeffrey.anderson@gmail.com 2004-11-29, 4:48 pm |
| Hi, I just got a job working in the IT Dept at my school, and I just
ran into my first error disable because of link-flapping. I was reading
around about what causes them and all I can find is people saying its a
faulty equipment or cable.
Is there anything else that could cause these errors?
| |
| Erik Freitag 2004-11-29, 11:47 pm |
| On Mon, 29 Nov 2004 14:37:45 -0800, jeffrey.anderson wrote:
> Hi, I just got a job working in the IT Dept at my school, and I just
> ran into my first error disable because of link-flapping. I was reading
> around about what causes them and all I can find is people saying its a
> faulty equipment or cable.
> Is there anything else that could cause these errors?
There's a good description of possible causes on the cisco website at:
http://cisco.com/en/US/customer/tec...shtml#ed_causes
top 3:
bad cable (too long, wrong type, defective)
bad network interface card (NIC) or driver
port duplex misconfiguration
you can cure the port duplex problem by setting the the duplex (and speed
while you're at it) to the same value on the switch port and the NIC (i.e.
full 100 on both ends). Not all NICs (including some installed in Cisco
gear) auto-negotiate speed and duplex properly.
| |
| jeffrey.anderson@gmail.com 2004-11-30, 4:48 pm |
| Thanks alot!
|
|
|
|
|